My tap has stopped in a cold snap. What should I do first?
Leave that tap open so melting ice has somewhere to go, make sure you can reach the main valve, and warm the space around the line gently. Then watch closely when flow returns, because a crack shows itself at the thaw rather than during the freeze.
An open tap serves two purposes. It relieves pressure as the ice releases, and it tells you the moment water starts moving again. Keep a torch and a bucket at hand and check the run where it crosses the coldest space, because that is where you will see the first drip.
Warm the area rather than attacking the pipe. Open the cabinet under a sink so room air gets to the supply lines, lift a crawl-space hatch so some house heat reaches down, and raise the thermostat for the day. If the frozen section is somewhere you cannot see or cannot reach, that is the moment to call rather than to start cutting into a wall in the cold.
Why does the damage appear after the cold has passed?
Ice is a plug as well as a hazard. While the section stays frozen the crack holds, so nothing escapes. As soon as the line thaws the plug clears and pressurised water finds the split, often in the warmest part of the afternoon.
Water expands as it freezes, and in a closed length of pipe that expansion drives pressure along the line rather than outward at the ice itself. This is why a split frequently appears at a fitting or a bend some way from the coldest point, and why a line that has frozen once is worth watching permanently afterwards.
It also means the worst timing is the most common timing. The thaw arrives mid-morning when the household has left for the day, and the water runs into an empty building for hours. If you know a line froze, do not leave the property unattended during the thaw, and if you must, turn the water off at the main until you are back.
Which parts of a Fort Collins house freeze first?
Lines in vented crawl spaces, unheated garages, attics and exterior wall cavities, plus anything feeding an outdoor tap. The pattern follows the unheated space the pipe crosses rather than the age of the plumbing itself.
In the older housing, where much of Old Town dates from the early twentieth century and earlier, pipework has usually been added and rerouted over decades, and it ends up in whatever space was available: along a crawl-space joist, up through an exterior wall, around the outside of a kitchen. None of those routes was chosen for frost protection.
Newer construction in Timnath, Windsor and Severance has better-insulated envelopes and mechanical spaces, but it concentrates risk differently, with upstairs laundry rooms and second-floor bathrooms whose supply lines pass through cold framing. Different buildings, same principle: find where the run leaves heated space, because that stretch is the one that decides your winter.
What makes one freeze loss cost more than another?
How long water ran after the thaw, how many splits there are along the line, whether the run sits above living space, how reachable the cavity is, and whether the building was occupied. Scope and price are explained and agreed before work starts.
A hose-bib split caught within an hour affects a short length of wall. The same freeze in an attic line that let go while nobody was home can involve a ceiling, two rooms and the floor below. Repeated splits along one cold run are common and each one has to be found, which is why locating work can take a share of the time on this kind of loss.
Access shapes the rest. Crawl spaces, tight attic runs and exterior cavities all slow the work compared with an open basement. No figures appear on this site because an honest number needs a visit, and a page cannot see your crawl space. What you are entitled to is a written scope, the reasoning behind it, and your approval before anyone starts. (833) 490-5225 is answered at any hour, including during the storm.
How do I keep it from happening again next winter?
Insulate the runs that cross unheated space, disconnect hoses before the first hard freeze, keep a genuine minimum temperature in buildings left empty, and know where the main valve is. Those four cover most freeze losses in ordinary houses.
Pipe insulation is cheap and works where cold air is the problem rather than a lack of heat. Sealing the obvious cold draughts into a crawl space or a garage matters just as much, since moving cold air takes heat out of a pipe far faster than still air does. Where a line simply cannot be protected, heat cable rated for the job and installed to its instructions is the usual answer.
Behavior matters more than equipment in two situations: a house that will be empty, and the first hard freeze of the season, which catches more pipes than any later cold spell because nothing has been prepared yet. The site's guide to frozen pipes in a Fort Collins winter sets out what to do before, during and after a cold snap.