Should I wait for the adjuster before drying starts?
Generally no. Most policies expect you to prevent further damage, and a building left wet keeps getting worse. The way to protect both interests is to document thoroughly first, then begin mitigation and keep logging it, rather than to pause the drying.
The reason this question comes up is a reasonable fear of destroying evidence. The answer is that photographs, readings and retained materials are the evidence, and once you have them the wet carpet is no longer carrying information that cannot be shown another way.
Tell your insurer that mitigation has started and when. Keep removed materials somewhere safe, in a garage or on a pallet, until the adjuster has seen them or released them.
What exactly should I photograph?
Each affected room from the doorway, the high-water mark, the source or failed component, wet flooring and wall bases, damaged contents individually, and model or serial labels on appliances. Then photograph again as material is removed, so the sequence is visible.
Think of it as three sets. The first establishes the scene and the extent. The second establishes the cause: the part, where it is, what it did. The third establishes value and loss: contents, item by item for anything significant, with labels and receipts where you have them.
Video is a useful supplement because it captures a room in one pass with your voice describing it, but it is not a replacement, since a still frame is easier to attach and to reference in a scope.
Do moisture readings matter to a claim?
They are the difference between asserting a building was wet and showing it. Dated readings on affected materials and on unaffected references, repeated daily, document both the original extent and the fact that the structure was dried properly before rebuilding.
Readings also justify the scope. A cut-out line on a wall, a floor taken up or a ceiling removed is much easier to defend as necessary when there is a reading behind it, and much harder to argue with afterwards.
They matter at the end as well. A log showing affected points matching unaffected references is the record that the work was finished rather than stopped, which is worth having if a problem appears in that room a year later.
Where do I go if I have a problem with my insurer in Colorado?
The Colorado Division of Insurance takes consumer questions and complaints through an online portal. Start with your insurer's own complaints route and keep your correspondence in writing, so that anything you escalate is supported by a documented sequence.
Before escalating, ask your insurer in writing for the specific reason for a decision and the part of the policy it relies on. A written answer is often enough to resolve a misunderstanding, and where it is not, it is the thing a complaint needs to point at.
We name the Division of Insurance as the complaint route and nothing more than that. We are not qualified to interpret your policy, quote deadlines or limits at you, or tell you what any claim should pay, and a restoration contractor that does any of those things is going beyond what it knows.
What changes the cost of the documented scope?
The number of rooms, how much material is affected, the drying days needed and the rebuilding involved. Documentation itself is part of how the work is run rather than a separate charge. The scope and price are explained and approved before work starts.
Where documentation does change the figure is by making it accurate. A scope built on readings reflects what is actually wet, which usually means less speculative removal than a scope built on appearance, and fewer surprises invoiced later.
No figures appear on this site, including national averages, because an average from another market is not information about your loss. After the walk-through you get a written scope, itemised room by room, and nothing starts until you have agreed it.