Phones answered 24/7Fort Collins, CO
Call (833) 490-5225
Urgent? Phones answered 24/7

Flood water extraction and pumping in Fort Collins

Standing water is pumped and extracted out of a building so that cleaning and drying can begin.

  • Spring Creek and Poudre flooding
  • Burn-scar debris flows
  • Freeze and thaw in pipes

Get a fast quote

Fastest: call (833) 490-5225. Or send this and we call you back.

Water Extraction

Flood Water Extraction and Pumping: what it covers

Quick answer

Extraction is the first stage of any flood job: standing water is pumped out, then pulled out of carpet and off hard floors with extraction units. Fort Collins Water Damage Restoration answers these calls 24/7 for Fort Collins and Larimer County and dispatches a crew as fast as one is available.

Flood Water Extraction and Pumping illustration for Fort Collins, CO

Nothing else in a water loss can start while there is standing water in the room. Dehumidifiers cannot pull a pond out of the air, air movers only push water around, and no sensible decision about what to cut out can be made while the floor is submerged. Extraction is therefore the stage that decides how long everything after it will take.

It is also the stage where mechanical capacity matters most. A truck-mounted or portable extraction unit removes far more water per hour than a wet vacuum, and a submersible or trash pump handles volumes and sediment that extraction gear would choke on. Which machine goes in is a judgment about depth, debris and where the discharge can legally go.

This page covers the extraction and pumping stage on its own, because it is often the only thing a caller wants at two in the morning. Fort Collins Water Damage Restoration will pump a building out, make it safe to walk in, tell you honestly what is and is not salvageable, and leave it ready for the cleaning and drying stages that follow.

Service area
Fort Collins & Larimer County
Availability
Phones answered 24/7, emergencies first
Warning signs

Signs you need flood water extraction and pumping

Do not enter standing water if it is anywhere near a live outlet, a cord, an appliance or the electrical panel; water carries current further than people expect. Never run a petrol pump or generator inside a building, a garage or a stairwell, because carbon monoxide in an enclosed space kills quickly. Do not pump a deep basement dry in one go when the ground outside is saturated, as the pressure difference can damage the wall. Wear boots and gloves in any flood water, and keep the discharge away from your own foundation and your neighbor's.

  • Standing water you can see across a floor at any depth
  • Carpet that releases water when you press it with a foot
  • Water visible through a crawl space hatch or a basement window
  • A sheen of water across a concrete garage or utility floor
  • Water running steadily from a ceiling, a wall or a stair nose
  • A rising mark on a wall, meaning the water is still coming in
  • Furniture or appliances sitting in water rather than on a damp floor
  • A floor drain or sump that is clearly not keeping up with the inflow
Options

Types and options for flood water extraction and pumping

Pumping a submerged basement or crawl space

Anything more than a couple of inches over a large floor is pump work rather than extraction work. The constraints are discharge route, power supply and how fast the level can safely be dropped. A crawl space adds the problem of getting a pump and a hose through a hatch designed for neither.

Extraction from carpet and padded floors

Carpet holds a surprising amount of water and the pad under it holds more. Weighted extraction heads press the water out of both while the vacuum pulls it away, and the process is repeated until the pass comes back dry. Where the water was contaminated the pad comes out instead of being extracted.

Hard floors, sub-floor voids and stairs

Water on tile, vinyl or sealed concrete looks easy and hides underneath. It travels into the joint between floor layers, under a vinyl sheet, into a floating floor's underlay and down a stairwell. Extraction is combined with lifting a section or drilling where readings show a void is holding water.

Commercial floors and large open areas

A warehouse, a shop floor or a church hall is a volume problem rather than a complexity problem, and it is solved with more machine and a planned discharge route. The priorities are usually stock, documents and keeping part of the building usable. The page on commercial flood and water restoration covers the wider job.

Need flood water extraction and pumping today?

Call any hour and explain what is going on. You get a clear price before any work starts.

How quickly does standing water have to come out?

As soon as it is safe for someone to work. The damage line in a wall rises for as long as water sits against it, because drywall, insulation and chipboard wick upward. Hours of standing water can turn a one-foot removal band into a two-foot one.

That is the whole argument for calling before morning. Wicking is steady and quiet, and the cost of the job is largely set by how high the water got into materials rather than how deep it stood on the floor. Getting the level down early limits what has to be cut out later.

The second reason is biological. Warm, wet, enclosed space with organic material in it starts to grow things within a couple of days, and once growth is visible the job changes character. Extraction is the cheapest intervention available in a water loss, and it is the one with the shortest useful window.

Why not just use a wet vacuum and a garden pump?

For a small, clean spill, those are fine and worth doing. For a flooded room they are too slow, they stop at the surface, and a garden pump will clog on sediment. The difference is water removed per hour against water wicking upward per hour.

Professional extraction units pull a far greater volume and, crucially, pull water out of materials rather than off them. A weighted head on carpet removes water the best domestic vacuum will leave behind, and that water is what keeps a room humid for a week afterwards. On a concrete floor the issue is reach rather than power: water sits in the joint and under finishes where a household tool never touches it.

There is also the discharge question. Water pumped to the wrong place runs back to the foundation, floods a neighbor, or goes somewhere it should not. A crew plans that route before it starts, which is one of the less glamorous reasons the job is worth handing over.

What happened on Jefferson Street in December 2019?

A water main roughly ninety years old froze and ruptured on Jefferson Street, flooding about a dozen businesses and City Hall. It is the clearest local example of a loss where the volume arriving meant that pumping, not drying, was the whole first day of work.

A main break and a creek flood look different on paper and identical on the floor: a large volume of water in a space that was never designed to hold any. The 1997 Spring Creek flood reached a Colorado State University library basement and first floor, which is the same problem at a different scale. In both cases the first question was how fast the water could be moved out.

For a business this stage decides what survives. Stock at floor level, document storage, servers in a basement room and anything on a bottom shelf are lost by the hour, so a crew will usually run extraction and contents removal at the same time rather than one after the other.

What makes extraction cost more in one building than another?

The volume of water, how far it has to be moved to a discharge point, how many rooms and levels are involved, the amount of sediment, and access. A clean basement with a nearby drain is the simple end. No figure is given here, because volume and access vary too much.

Volume sets the machine time, access sets the labor, and sediment sets both. Carrying pumps and hose down an outside stair, running a long discharge line to a legal outfall, or working through a crawl space hatch all add hours that have nothing to do with how much water there is. Contaminated water adds protective equipment, containment and disposal.

The other factors are whether power is available, whether the water is still coming in, whether contents have to be moved before the floor can be worked, and how many separate spaces need their own setup. Fort Collins Water Damage Restoration explains the scope and the price before work starts and gets your approval, and raises anything unexpected with you rather than at the end.

What can a homeowner safely do before the crew arrives?

Shut off the water source if the loss is a plumbing one and you know the valve. Photograph everything at its current depth. Lift small items off the floor onto something non-absorbent. Then stay out of the water if power or gas is anywhere near it.

The three highest-value actions are all free. Stopping the inflow, where you can do it safely, stops the job growing. Photographs of the water at its deepest are the only record that will exist of how bad it was. Getting paper, electronics, books and textiles up off the floor saves items that no cleaning process recovers.

What not to do is push water around with a broom, run a household vacuum on a wet floor, or start a petrol pump indoors. Call (833) 490-5225 and someone will talk you through the specific building rather than giving generic advice. The page on structural drying and dehumidification explains what happens after the water is out.

Our process

How our flood water extraction and pumping visit works

  1. Make the space safe to enter

    Power is confirmed off where water is near circuits, outlets or a panel, and gas appliances in the water are flagged. A technician does this before any equipment is carried in. If the honest answer is that nobody should enter yet, you will be told that rather than watched entering.

  2. Measure and record before pumping

    Depth is measured, the high-water mark is photographed and the inflow is identified, because once the water is gone that evidence cannot be recreated. These few minutes are what later supports a claim. The notes also tell the crew whether the water is still rising.

  3. Pump the bulk water out

    A submersible pump handles clean or lightly soiled water; a trash pump is used where sediment, grit or debris would block an impeller. Discharge is routed to a legal and sensible point, away from the foundation and not into a space that will send it back. Deep basements are lowered in stages to protect the walls.

  4. Extract what the pump cannot reach

    Below pump level the work moves to extraction units: a wand and weighted heads on carpet, squeegee extraction on hard floors, and specialist tools for sub-floor voids and stair treads. This is where most of the water actually trapped in materials comes out. Multiple passes matter more than a single slow one.

  5. Hand the space over ready for the next stage

    The crew records depths, times, volumes where measurable and the state of each room, and says plainly what is salvageable and what is not. If you only booked extraction, that report is yours to use. If drying follows, equipment is set the same visit.

Larimer County

Why flood water extraction and pumping is different in Northern Colorado

Because so much of the local flood record is creek and river water, the water pumped out of a Fort Collins building is often not clean, and that changes the tools. Sediment from the Cache la Poudre or a creek channel will stop an ordinary pump, which is why a trash pump and a sediment plan go on the truck for any call in a flood corridor. Discharge also has to be placed carefully when the ground outside is already saturated.

Winter work has its own constraint. Fort Collins sits between cold Arctic air arriving from the north and warm Chinook winds off the mountains, so a freeze can follow a loss within a day; pumped water left standing on a drive or against a wall becomes ice, and a hose run outside overnight can freeze solid. Discharge routing in cold weather is planned around that rather than improvised.

Old Town's buildings date largely from the early twentieth century and earlier and the area has been on the National Register of Historic Places since 1978, which affects how water gets removed from them. Original floors, plaster and trim mean extraction heads and hand tools rather than quick demolition, and the crew works out what can be lifted and relaid instead of what can be skipped. It is slower, and on these buildings it is the right call.

Related

Basement Flooding After Heavy Rain

A basement that takes water in a storm is pumped out, stripped where needed, and dried under readings before anything is rebuilt.

Spring Creek Flood Damage

Flood water from the Spring Creek corridor is pumped out, contaminated materials removed, and the structure dried to readings.

Guides

Read before you book

Is my Fort Collins home in a floodplain?

Fort Collins Utilities holds floodplain status for a specific property, and that is where the question is settled rather than by a neighbor or a listing.

Burn scar flash floods above Fort Collins: what to do

A burned slope sheds rain instead of absorbing it, so a short, intense storm over the Cameron Peak burn scar can send a debris flow of water, mud, rock and charred timber down a drainage within minutes.

Why Old Town Basements Flood in Heavy Rain

Old Town basements flood because the oldest part of Fort Collins drains through a storm sewer system built for far less water than a big thunderstorm delivers.

FAQ

Flood Water Extraction and Pumping FAQs

Can I book extraction only and do the rest myself?

Yes, and some people do. You will get the water out, a written note of depths and conditions, photographs, and an honest view of what will and will not dry. What you take on is the drying, which is where most self-managed jobs come unstuck, because a room can feel dry while the framing is not.

How long does pumping a flooded basement take?

The pumping itself is often a few hours; the extraction that follows usually takes longer. Depth, pump access and the discharge route decide it, and a deep basement is lowered in stages on purpose. You will be given a working estimate once someone has seen the space.

Where does the pumped water go?

To a legal and sensible discharge point agreed before pumping starts, away from the foundation and not into a space that will drain straight back. Contaminated water is handled differently from clean water. If the only available route raises a question, the crew will say so instead of just running a hose.

Do you extract from crawl spaces?

Yes, and it is slower than a basement because everything has to pass through the hatch. Pumping is followed by removing wet vapour barrier where sediment got underneath it. Crawl space work is scoped separately because its drying plan is different from a room's.

Is the floor safe to walk on once the water is gone?

Usually, but a wet floor is slippery and a sub-floor that has been submerged can be soft. Treat a wet timber floor near a stair or a hatch with care. Where a crew has doubts about a floor it will say so and keep people off it until it is checked.

Will extraction save my carpet?

It can, where the water was clean and the pad can be dried or replaced promptly. After creek, storm or drain water the pad comes out and the carpet is judged separately. Extraction is still worth doing first, because it limits how far the water travels into the structure.

Can you come out in the middle of the night?

Phones are answered 24/7 and a crew is dispatched as fast as one is available. In a storm that has hit many buildings at once, that is honest rather than instant, and you will be told where you stand. Nobody here promises an arrival time.

WhatsApp